led shop light bulbs How to Install Work Lights in the Garage

by:Leimove     2019-05-24
led shop light bulbs How to Install Work Lights in the Garage
A lot of people like to turn their garage into a woodworking workshop, transforming cars or other hobbies.Unfortunately, most garages have only one light bulb in the center of the room to illuminate the entire space, which is almost not enough for many missions.Fortunately, there is a simple and cheap solution where you can install work lights in the garage without having to crawl in the attic space above the garage or wiring any circuits.Turn on the garage door for ambient lighting and turn off the light switch for overhead garage lights.Put a ladder under the garage door light.Climb the ladder and screw the light bulb.Screw the lamp holder adapter with socket on both sides of the adapter into the lamp holder, and then screw the bulb into the bottom of the lamp holder adapter.Find the nearest ceiling pallet in the work area, where you want to install the lights with the stud finder.Mark the position of the beam on the ceiling with a pencil.Measure the distance between the two chains mounted on 4-Foot mounted fluorescent lamps with power cord.Find a point on the ceiling directly below the ceiling beam, where you want one of the two hooks where the hanging lights are installed, and then twist a 4-Inch screw hook through drywall and ceiling support beam.Screw the hook into the support beam by hand until the hook is bent at the beginning, about 1/4 below the drywall.Measure the same length as the two brackets at the top of the fixture from the mounted hook along the ceiling pallet and insert the second 4-In this place, the inches hook into the support beam.Hang the two mounting chains on the hooks on the ceiling.Adjust the height of the fixture by hooking the higher or lower rings on the chain to the desired height.The two chains should have the same chain ring attached to the hook so that the fixture can be horizontal.Insert a pair of 4-Put the foot fluorescent bulb into the fixture.Wrap the power cord of the fixture on the nearest hook, then feed it into the fixture adapter and plug the power cord plug into a socket on the side of the lamp socket adapter.Turn on the garage light switch and test whether the fixture is turned on and off using the garage light switch.Turn off the garage lights and secure the power cord to the ceiling between the lamp socket adapter and the hook wrapped by the power cord using a hammer and a wire spike.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...