small screw led bulbs How to Make a Fishing Bait Boat

by:Leimove     2020-03-17
Bait boat for fishing Big carp.These little radiosControlled (RC) vessels allow anglers to slide into the area where the carp School is located by boat.The RC boat is quiet and can slide into the area without disturbing the carp.The anglers pull or pull a line attached to the ship, which drops a bait line on the fish.A kit (see reference 1) or a small RC boat is required for bait fishing for the construction and manufacture of the bait boat.Description difficulty: Place two hull floats of the bait boat kit on a flat work area.Connect the bait holder with a small screwdriver.Connect the radio antenna to the end of the bait boat.Make sure the antenna is placed towards the rear of the ship.Tighten the connection point with a small screwdriver.Plug the battery charger into the wall socket from the kit.Put the bait boat battery into the charger to charge until the light display changes from red to green, indicating full power.Take out the battery and put it into the bait boat battery compartment.Jet propulsion engine by color-Coded wire accessories.Attach the green wire to the green metal tongue holder and attach it to the fixing screw.Attach the red line to the red metal tongue accessory and attach it to the fixing screw.Seal the edges and seams of the boat with a water seal in the kit.Run the sealing material along the edges and seams to let it dry.According to your kit plan, put the LED lights on the bait boat.Look for the installation dents where the LED lights are located, and where the lights draw the lighting power from the battery on board.Add batteries to RC phones.Turn on the power and wait for the RC phone display to appear.Set the frequency of the controller to ship-Screen menu and instructions.Verify with local law enforcement agencies or FCC offices the rules or laws for using RC frequencies on board.Slide the split shooting magnet to the bottom of the fishing line, one to 2 inch above the hook.Place the magnet at the end of the bait boat, between the jet propulsion zone, where a sheet of metal is used to hold the magnet.Eric Cedric, once an Alaska native, has lived in California for 20 years.He published it on "outside" and "backpacker" and wrote a book about small-Alaska town, north-southeast.Cedric has been a professional mountaineering guide and field expedition leader for 18 years.He has worked in Russia, Iceland, Greece, Turkey and Belize.Cedric is a private pilot at Syracuse University.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...